A pipe usually fails inside a wall cavity, which means the visible damage is only a fraction of what's actually happening behind the drywall.
We open the wall cavity carefully, only as far as moisture readings say is necessary, rather than tearing out an entire wall.
Stopping the water source is priority one before any extraction begins.
We use pressure testing and moisture tracing to locate exactly where a supply line failed inside the wall.
We open wall cavities in a controlled, targeted way based on documented moisture data.
Handoff to a licensed plumber is built into our burst pipe process, not left for you to arrange separately.
A burst pipe call has a specific sequence — find the source, stop it, open only what's necessary, and coordinate repair — here's how our Inverness, FL crews run it.
If the source is still running, shutoff is priority one.
We locate the failure point before opening any drywall, avoiding guesswork demolition.
Wall cavity extraction addresses moisture a surface-level approach would miss.
Targeted removal limits the repair scope to what's actually necessary.
Drying continues until wall cavity moisture readings hit dry standard.
We coordinate scheduling with a licensed plumber for the pipe repair itself.
We'll walk you through locating the shutoff valve over the phone if needed.
Equipment for wall cavity work is brought along by default for burst pipe calls.
You'll see the scope and cost once the failure point is confirmed.
Final sign-off includes verified dry readings and a repair handoff.
"They found our shutoff valve in about thirty seconds since we had no idea it existed, then got straight to work on the wall." — Holly T.
"Only opened up the section of wall that was actually wet instead of the whole thing. Saved us a lot on drywall repair." — Andre L.
"They coordinated directly with our plumber so the pipe got fixed the same week the wall was already open." — Priscilla W.
We can confirm which you're dealing with during the initial assessment.
Only the compromised section comes out, not the full wall.
We can refer a plumber or work alongside yours to keep the timeline aligned.
Avoid the area near standing water and electrical outlets until our technician confirms it's safe.
Wall cavity drying typically takes 3-5 days depending on how much insulation and framing was affected.
If your address is in or near Inverness, a crew can typically respond the same day.
Speak directly with our burst pipe response team.
Call +1-844-578-1604